Advanced Logic Research Solo 9100 Especificações Página 47
- Página / 108
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
36 Maintaining and Troubleshooting Your E-4200 System
7.
Configure the new drive by following your drive documentation.
8.
Do one of the following:
•
If you are replacing the hard drive that is installed in the cage,
remove the drive from the cage and install the new drive in its
place.
•
If you are adding an additional hard drive, install the drive in the
empty bay of the drive cage.
9.
Reinstall the drive cages into the case.
10.
Close the case as describe in Chapter 1.
11.
Plug in the power cable and peripherals.
12.
Turn on the computer.
If the system does not recognize the new drive, see “Hard disk
problems” on page 73 for troubleshooting information.
Replacing the CD-ROM drive in your desktop computer
A 5.25-inch drive is secured to the same metal mounting cage as the
3.5-inch drive. A 5.25-inch drive, such as a CD or DVD drive, can be
installed in this location.
1.
Turn off the system and disconnect the power cord.
2.
Remove the cover side panels, observing the “Static electricity
precautions” on page 2.
3.
Locate the combination 3.5-inch drive/5.25-inch drive cage.
4.
Disconnect the power and data cables from the back of both drives,
noting their locations and orientations. (You will reconnect these
cables after you install the new drive.)
To replace the CD-ROM drive in the center bay
- Maintaining and 1
- Troubleshooting 1
- Your E-4200 1
- All Rights Reserved 3
- Trademark Acknowledgments 3
- Contents 4
- User’s Guide 7
- Safety instructions 8
- The Gateway Support Center 9
- The System Restoration CD 10
- Chapter 1: 12
- Case Access 12
- Caution! 13
- Warning! 13
- Case Access 3 14
- Mid-tower case 14
- Tower case 14
- Desktop case 14
- Opening the case 15
- Case Access 5 16
- Removing the tower case cover 18
- Right side 19
- Left side 19
- Replacing the cover 20
- To close the tower case 22
- Chapter 2: 24
- Components 24
- Locating components 25
- Mid-tower components 26
- Tower components 27
- System board 28
- I/O connectors 30
- Front panel I/O connections 31
- Setting the jumpers 32
- Recovery mode 33
- Replacing the processor 34
- AB to display 38
- Installing memory 40
- To remove DIMMs 41
- System Components 31 42
- Important! 42
- System Components 33 44
- To install a hard disk drive 45
- System Components 35 46
- System Components 37 48
- System Components 39 50
- System Components 41 52
- System Components 43 54
- System Components 45 56
- System Components 47 58
- System Components 49 60
- Add-in card guide 60
- (in some 60
- Middle hard 61
- System Components 51 62
- System Components 53 64
- Bottom hard 64
- Adding an expansion card 66
- Add-in card bracket 67
- (tower system only) 67
- LM81 hardware management 68
- Installing LANDesk Client 69
- Replacing the battery 69
- System Components 59 70
- Replacing the power supply 71
- System Components 61 72
- System Components 63 74
- Chapter 3: 76
- BIOS Setup 76
- About the BIOS setup utility 77
- Updating the BIOS 78
- Chapter 4: 80
- Introduction 81
- Troubleshooting checklist 81
- Troubleshooting guidelines 82
- CD-ROM problems 83
- Hard disk problems 84
- Memory/Processor problems 85
- Modem problems 86
- Peripheral/Adapter problems 87
- Troubleshooting 77 88
- Printer problems 89
- System problems 90
- Video problems 91
- Troubleshooting 81 92
- The video is distorted 93
- Error messages 94
- Troubleshooting 85 96
- Appendix 98
- Specifications 99
- Appendix 89 100
- Attention! 101
- Caution! 102
- Index 93 104
- Index 95 106
Ge-pw E-Series Reverse Osmosis - E4 50 Hz manuály
Uživatelské manuály a uživatelské příručky pro Vodní zařízení Ge-pw E-Series Reverse Osmosis - E4 50 Hz.
Poskytujeme 1 manuály pdf Ge-pw E-Series Reverse Osmosis - E4 50 Hz ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Comentários a estes Manuais