Advanced Logic Research Solo 9100 Especificações Página 63
- Página / 108
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
52 Maintaining and Troubleshooting Your E-4200 System
10.
Close the computer case (see “Replacing the tower case cover” on
page 11 for instructions). Plug in the power cord and turn on the
computer.
If the system does not recognize the new drive, see “Hard disk problems”
on page 73 for troubleshooting information.
Installing hard drives in the bottom drive cage
You can install 3.5-inch hard drives in the bottom drive cage.
1.
Turn off the system and unplug the power cord.
2.
Remove the right side panel of the case (see page 7 for instructions),
observing the “Static electricity precautions” on page 2.
3.
If any drives are installed in the drive cage, disconnect the cables from
the back of the drives.
4.
If your system includes an add-in card guide, remove it:
A.
Remove any long add-in cards attached to the card guide.
B.
Remove the screw that attaches the add-in card guide to the chassis
and then slide the card guide out of the computer.
To install a drive in the bottom drive cage
- Maintaining and 1
- Troubleshooting 1
- Your E-4200 1
- All Rights Reserved 3
- Trademark Acknowledgments 3
- Contents 4
- User’s Guide 7
- Safety instructions 8
- The Gateway Support Center 9
- The System Restoration CD 10
- Chapter 1: 12
- Case Access 12
- Caution! 13
- Warning! 13
- Case Access 3 14
- Mid-tower case 14
- Tower case 14
- Desktop case 14
- Opening the case 15
- Case Access 5 16
- Removing the tower case cover 18
- Right side 19
- Left side 19
- Replacing the cover 20
- To close the tower case 22
- Chapter 2: 24
- Components 24
- Locating components 25
- Mid-tower components 26
- Tower components 27
- System board 28
- I/O connectors 30
- Front panel I/O connections 31
- Setting the jumpers 32
- Recovery mode 33
- Replacing the processor 34
- AB to display 38
- Installing memory 40
- To remove DIMMs 41
- System Components 31 42
- Important! 42
- System Components 33 44
- To install a hard disk drive 45
- System Components 35 46
- System Components 37 48
- System Components 39 50
- System Components 41 52
- System Components 43 54
- System Components 45 56
- System Components 47 58
- System Components 49 60
- Add-in card guide 60
- (in some 60
- Middle hard 61
- System Components 51 62
- System Components 53 64
- Bottom hard 64
- Adding an expansion card 66
- Add-in card bracket 67
- (tower system only) 67
- LM81 hardware management 68
- Installing LANDesk Client 69
- Replacing the battery 69
- System Components 59 70
- Replacing the power supply 71
- System Components 61 72
- System Components 63 74
- Chapter 3: 76
- BIOS Setup 76
- About the BIOS setup utility 77
- Updating the BIOS 78
- Chapter 4: 80
- Introduction 81
- Troubleshooting checklist 81
- Troubleshooting guidelines 82
- CD-ROM problems 83
- Hard disk problems 84
- Memory/Processor problems 85
- Modem problems 86
- Peripheral/Adapter problems 87
- Troubleshooting 77 88
- Printer problems 89
- System problems 90
- Video problems 91
- Troubleshooting 81 92
- The video is distorted 93
- Error messages 94
- Troubleshooting 85 96
- Appendix 98
- Specifications 99
- Appendix 89 100
- Attention! 101
- Caution! 102
- Index 93 104
- Index 95 106
Ge-pw E-Series Reverse Osmosis - E4 60 Hz manuály
Uživatelské manuály a uživatelské příručky pro Vodní zařízení Ge-pw E-Series Reverse Osmosis - E4 60 Hz.
Poskytujeme 1 manuály pdf Ge-pw E-Series Reverse Osmosis - E4 60 Hz ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Comentários a estes Manuais